Camera

Inside

Play with GPIO port 1:

#set all to output
iwpriv wlan0 write_mem dw,b8003508,1,ffffffff
iwpriv wlan0 write_mem dw,b800350c,1,ffffffff
iwpriv wlan0 write_mem dw,b800350c,1,00000000

Play with GPIO port 2:

iwpriv wlan0 write_mem dw,b8003524,1,ffffffff
iwpriv wlan0 write_mem dw,b8003528,1,ffffffff

Config reg:

# iwpriv wlan0 read_mem dw,b8000040,1
wlan0     read_mem:0  0  12  3 
# iwpriv wlan0 read_mem dw,b8000044,1
wlan0     read_mem:0  241  52  219

smb mount:

mount -t cifs //192.168.2.10/jara -o username=jara,password=xxx /mnt/smb

Flash firmware - only root filesystem:

Booting...

********************************************************************************
*
* chip__no chip__id mfr___id dev___id cap___id size_sft dev_size chipSize
* 0000000h 0c22017h 00000c2h 0000020h 0000017h 0000000h 0000017h 0800000h
* blk_size blk__cnt sec_size sec__cnt pageSize page_cnt chip_clk chipName
* 0010000h 0000080h 0001000h 0000800h 0000100h 0000010h 000002dh MX25L6405D
* 
********************************************************************************

---RealTek(RTL8196D)at 2014.07.22-19:57+0800 v0.3 [16bit](659MHz)
P0phymode=01, embedded phy

---Ethernet init Okay!
<RealTek>
**TFTP Client Upload, File Name: oot.bin
-
**TFTP Client Upload File Size = 0042E002 Bytes at 80500000

Success!
<RealTek>flw 140000 80500000 0042E002
Write 0x0042e002 Bytes to SPI flash#1, offset 0x00140000<0xbd140000>, from RAM 0x80500000 to 0x8092e002
(Y)es, (N)o->y
.............................................................................................................................................................................
.............................................................................................................................................................................
.............................................................................................................................................................................
.............................................................................................................................................................................
.............................................................................................................................................................................
.............................................................................................................................................................................
.................................<RealTek>

Change mode to client and connect to wifi:

# iwpriv wlan0 set_mib opmode=8
# iwpriv wlan0 set_mib ssid='burty'
# ifconfig wlan0 down
# ifconfig wlan0 up  
Switch to channel 7 before doing 88E IQK
# ifconfig wlan0 192.168.168.99 netmask 255.255.255.0
# ping 192.168.168.20
PING 192.168.168.20 (192.168.168.20): 56 data bytes
64 bytes from 192.168.168.20: seq=0 ttl=64 time=10.000 ms
^C
--- 192.168.168.20 ping statistics ---
1 packets transmitted, 1 packets received, 0% packet loss
round-trip min/avg/max = 10.000/10.000/10.000 ms
#
hw
Není-li uvedeno jinak, obsah této stránky je pod licencí Creative Commons Attribution-ShareAlike 3.0 License